The MTP-330 Track Press can disassemble and assemble track links o even the largest bulldozers in operation. Now turning the pins and bushes or completely replacing the link components, of even the largest tractors in the field is much easier and faster with this larger capacity track press.

The major features are as follows:

This press has a zero deflectio frame at a full 330 tons of pressure on both rams. The unique design of the machine consists of a massive cross section frame and a tension bar. This design forms the basis for the strongest, most rigid press frama available.

A sliding door seperates the work area preventing injury from shattered metal which can occur at 330 tons of pressing force. A shatterproof window provides a clear view of the entire operation. The door has wide frontal openings for ease of tool changing and ball bearing suspension for smooth, easy operation.

The cylinder mounts, tool bars and the jaws are located on precisely machined surfaces for unsurpassed accuracy. Each of the tool heads is carried on lubricated brass slide bearings to assure tolerance in tooling alignment.

This press has a longer ram stroke and it allows the use of 100 series safety toolings. There is no longer any need of holding the track link in position by hand while assembling with 100 series toolings. It is safer, with faster and more efficient operation.

A single lever controls both the raising and lowering of the table and the indexing of the link. Further, an adjusting rod and nut are provided for fixing the proper indexing pitch according to the link of the tractor models. This makes the track press much faster. Also, presetting a 1/2 pitch backward and forward is available, which is required for assembling the links on some specific tractor models.

The winch control lever is now located very close to the winch to facilitate the operators job though it was located near the main equipment operating levers.